Correction of Short Nose Using M-shaped Cartilage in Asian Patients: Finite Element Analysis and Recommendations for Surgery.

[BACKGROUND] Using M-shaped cartilage grafts is a new method for the correction of short nose deformity with good effect for Asians. Although the basic approach to M-shaped cartilage surgery is well understood, there is a great deal of uncertainty when plastic surgeons perform the procedure, and still a lack of standard guidance on the specific details.

[METHODS] In this study, the authors used finite element analysis to explore and compare postoperative cartilage stability of different fixing methods, different suturing positions, and different sizes of M-shaped cartilage. The authors applied a 0.01 N load to a 1 cm area of the nasal tip to simulate nasal tip palpation and compared the maximum deformations of different groups, which were used to make stability judgments.

[RESULTS] The maximum deformation of the model was the least when the M-shaped cartilage was fixed medially to the septal cartilage and laterally to the outer crura of the lower lateral cartilage. At the same time, the maximum deformation was the least when the M-shaped cartilage was sutured to the middle of the nasal septal cartilage. Besides, the length of M-shaped cartilage was preferably around 30 mm, while its width was not worthy of being overly concerned.

[CONCLUSIONS] For optimal postoperative stability of Asian short nose correction, the M-shaped cartilage should be sutured and fixed medially to the middle of the septal cartilage and laterally to the lateral crura of the lower lateral cartilage, and the length of the M-shaped cartilage should be controlled at around 30 mm.

[LEVEL OF EVIDENCE IV] This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .